Filter datasheet

Variants

Material data sheet

Steel grade

  • SBC35E
Last revised: Thu, 12 Dec 2019 08:57:36 GMT

General Information

C35 is a medium Carbon steel, one of the most widely used for machinery parts. Exellent forgeability. Special variants ca be made avaiable for cold drawing. Due to the carbon content preheating and postheating are required when welding. Wide range of mechanical properties can be attained by quenching and tempering. 

Similar designations

C35E, DIN Ck35, 080M36, XC38, 1035, GOST 35

As quenched hardness should be approximately 45 HRC

Other properties (typical values)

Youngs module (GPa)Poisson´s ratio (-)Shear module (GPa)Density (kg/m3)
210 0.3 80 7800
 Average CTE 20-300°C (µm/m°K) Specific heat capacity 50/100°C (J/kg°K) Thermal conductivity Ambient temperature (W/m°K) Electrical resistivityAmbient temperature (µΩm)
 12  460 - 480  40 - 45  0.20 - 0.25

Contact us

Would you like to know more about our offers? Don´t hesitate to contact us:

Via e-mail: info@ovako.com 

Via telephone: +46 8 622 1300

For more detailed information please visit http://www.ovako.com/en/Contact-Ovako/

  

 

Disclaimer

The information in this document is for illustrative purposes only. The data and examples are only general recommendations and not a warranty or a guarantee. The suitability of a product for a specific application can be confirmed only by Ovako once given the actual conditions.The purchaser of an Ovako product has the responsibility to ascertain and control the applicability of the products before using them. Continuous development may necessitate changes in technical data without notice. This document is only valid for Ovako material. Other material, covering the same international specifications, does not necessarily comply with the properties presented in this document.